How should the microphone of gaming wired headphones be cleaned and maintained?

The microphone cleaning and maintenance of gaming wired headphones requires certain skills and methods, the following are specific recommendations:

Daily cleaning

• Surface cleaning: After using the microphone, gently wipe the surface with a clean, soft dry cloth to remove dust, stains and skin oils. If there are stubborn stains, wring out a slightly wet (not wet) soft cloth and wipe it, and then wipe it with a dry cloth to prevent water from entering the microphone.

• Cover cleaning: The cover of the microphone is prone to accumulation of dust and debris, you can use a soft brush (such as a makeup brush or a special cleaning brush) gently brush the surface of the cover dust. Be careful to act gently to prevent damage to the net cover. For the more difficult to clean the stains, you can use less sticky tape, gently stick on the net cover, and then tear off, can stick to remove some dust and small particles of debris.

Deep cleaning

• Detachable microphone: If the headset's microphone is detachable, it can be removed for a more thorough cleaning. Mix warm water with a small amount of mild cleaner (such as dish soap), soak the microphone mesh cover part in the solution for a few minutes, and then gently wash with a soft cloth or brush to remove dirt. After cleaning, rinse with water and let dry naturally in a well-ventilated place. Make sure that the headphones are completely dry before installing them back.

• Non-removable microphone: For non-removable microphone, use a cotton swab dipped in a small amount of alcohol, gently wipe the microphone surface and net cover, but be careful not to excessive alcohol, so as not to flow into the inside of the headset to cause damage. After wiping, let the alcohol evaporate and dry naturally.

Maintenance points

• Avoid pulling and collision: When using and storing headphones, pay attention to avoid pulling the microphone's connection wire to prevent line damage. At the same time, do not allow the headset to be violently collided or dropped, so as not to cause the internal components of the microphone to loose or damage.

• Moisture protection: The microphone should be stored in a dry, ventilated environment to avoid moisture. Moisture may cause rust, short circuits, or reduced performance of the internal components of the microphone. If the headset has been used in a humid environment, it should be dried in time and put in a dry place to dry.

• Correct use: When using the microphone, maintain an appropriate distance and Angle, and do not get too close to the mouth or shout at the microphone, so as not to cause sound distortion or damage the microphone. At the same time, avoid using headphones in an environment with a strong magnetic field or strong static electricity, so as not to interfere with the microphone.

• Regular inspection: Regularly check whether the appearance of the microphone is damaged or whether the mesh cover is loose. You can also check the sound effect of the microphone through the audio test function of the software or the device, and deal with the problem in time.